DG834 in modem-only mode. How to access interface?

[arvarius]

Apologies for the noob question.

I followed the guide on
http://forum1.netgear.com/showthread.php?t=6072

to change my DG834 into modem-only mode as I bought a new buffalo WHR-HP-G300N router and wanted the DG834 to act as modem-only.

However, once i switched the DG834 to modem-only, i wasn't able to access the web interface anymore.

Can anyone tell me how i can access the web interface? I can't connect to the internet, so i wanted to try switching it to LLC.

Many thanks

[simononthequay]

I have the same question. I have a DG834 in modem-only mode connected to a Netgear WNDR3700. I am trying to get Sky Anytime + to work and I suspect I need to upgrade the firmware or change the settings of the DG834. But now I don't know how to access the DG834. Many thanks.

[jmizoguchi]

Normally you do not have access once it is on modem mode

[simononthequay]

Thanks, but I think I need to get to the interface. Do you know how this is done?

[jmizoguchi]

why you need to get in?

[simononthequay]

I am trying to get Sky Anytime+ to work. Elsewhere I have read I might need to change the multiplexing method, whatever that is, to LLC-based, or that I might need a firmware update. My set up is a WNDR3700 connected to DG834 in modem-only mode. It's all gooblygook to me but I thought if I could access the DG*£$ and tinker with the settings I might get it to work. Sky is the only thing that doesn't work with this set up.