Firmware upgrade Question. ?

[slyst]

If i upgrade the firmware on my XAVB5001 plugs will i need to redo the Push-and-Secure buttons on the side of the plugs or will it keep the old settings so the plugs are still working and secured. ?

Thankyou.

[jmizoguchi]

in most cases, you want to hard rest the device to load the firmware correctly which means you loose the settings.

it may not loose setting just flashing firmware but always wise to reset the device

[slyst]

When i try and upgrade the firmware from v0.2.0.9.CE to the latest v2.0.0.0 i get the following error message.

"Either no NETGEAR adapter can be found or all devices have the newest firmware."

Any ideas. ?

[jmizoguchi]

first utility must find two of your power line devices. you may need to put oth in the same room where it is on some circuit

[clithes]

As far as I can see version 0.2.0.9CE is the latest version (this is the European version pre-installed), Upgrade tool 2.0.0.0 will put version 0.2.0.9NA onto the adapters, which is simply the American version of the same firmware

[gehx]

this is what the util shows me:


when i attempt to upgrade the util says this:


so are they running the latest fw?

[gehx]

Originally Posted by clithes

As far as I can see version 0.2.0.9CE is the latest version (this is the European version pre-installed), Upgrade tool 2.0.0.0 will put version 0.2.0.9NA onto the adapters, which is simply the American version of the same firmware

ok, this is what the fw upgrade util shows me (both devices are connected in the same room on the same circuit when i attempt to upgrade):



and i get this when pressing next:



so my question is, am i running the latest fw?

[gehx]

Bump... 10char?

Originally Posted by gehx

ok, this is what the fw upgrade util shows me (both devices are connected in the same room on the same circuit when i attempt to upgrade):



and i get this when pressing next:



so my question is, am i running the latest fw?

[clithes]

Yes is means you are running the latest firmware (at the time). Since then a new firmware has been released (v0.2.1.1CE) which you can now update to

[gehx]

Originally Posted by clithes

Yes is means you are running the latest firmware (at the time). Since then a new firmware has been released (v0.2.1.1CE) which you can now update to

hmm..all of my adapters are showing v0.2.0.9NA and the upgrade util says they don't need to be updated? do you have any thoughts as to why this might be?