[WNR2000v2][Firmware update] 1.2.0.4_35.0.57: flaw in "attached devices" section

[Tyf0x]

Hi,

I updated my router's firmware this morning and I noticed a problem in the "Attached devices" section: When I access it everything is OK but if I click the "refresh" button some code (probably javascript) is dumped in the result table.
I tried to re-install the firmware from a newly downloaded file from the official website, restart the router, reset the settings, ... but nothing changed.

I found a similar thread but the problem seemed to have been misunderstood since the description is close to my problem (http://forum1.netgear.com/showthread...signed+devices).

Here are two screenshots showing the "attached devices" section before and after pressing the refresh button:

BEFORE:


AFTER:

Thanks for your feedbacks!

[jmizoguchi]

WNR2000 is NOT access point products.. it is wireless router .

belong here

http://forum1.netgear.com/forumdisplay.php?f=33


After each firmware upgrade you MUST hard reset specially when you get erratic behavior.

see router reset on my sig below



if still the same POST at ABOVE URL ...

[Tyf0x]

Apologies for posting in the wrong section. Can you move it to the good one ?

Anyway, I already did a hard reset to the router and just tried all the steps mentionned there: http://vpncasestudy.com/reset.html#resetprocedure

I still have this result, with or without restoring the configuration.
Also tried to reflash the firmware multiple times without better results.

Would you consider this as a bug? Anyone having the same issue ?

[jmizoguchi]

Go back to prior firmwre a d if it fixes , call support for but at my.netgear.com

[Tyf0x]

Reverted to firmware v1.0.0.40 and all is back to normal. Submitted a ticket to my.netgear.com.

Thanks

[jmizoguchi]

your welcome..

hope it get's fixed...