FVS318N access gui via vpn tunnel

[jame_s]

i have a vpn tunnel working to a remote FVS318N.
i can access the GUI using the unit's wan IP address no problem.
i can access the gui using the local address from the local subnet no problem.
i can't get the gui to respond when trying to access it from a remote tunneled address that it can be pinged from

e.g. ping 192.168.10.1 (the FVS) from 10.2.32.1 (my pc) via vpn tunnel pings ok
accessing https://192.168.10.1/ from 10.2.32.1 via vpn tunnel doesnt work, chrome says that no data is returned.
i've added 10.0.0.0/8 as being allowed to remotely admin.

otherwise the vpn tunnel seems to be working normally.

any ideas anybody?

[swnunes]

I have the same issue with my hub and spoke vpn setup. I have a FVS338 for the hub and a combination on FVS318 and FVS318n routers at the spokes. I can access the 318's through the vpn tunnel but not the 318n's. As far as I know everything is configured the same on all routers.

[Daedalus01]

Check to make sure all firewalls are off and try again. Also, posting your config would be beneficial as well. Hard to know what could be wrong without seeing it.

[jmizoguchi]

old FVS318 uses in VPN policy with local and remote IP ending with last octet 0
ex 192.168.10.0/255.255.255.0

in FVS318N on newer interface local and remote ip ending with last octet 1

ex 192.1683.10.1/25.255.255.0


This can make difference in tunnel

[Daedalus01]

Weird. I was unaware of that as I do not have that particular model.