mbrn3000 loses settings

[hans3]

my mbrn3000 was working well one year, now he loosed his settings 2 times.
It works with the UMTS Modem MF 190 with Bob (Austria) very well. The loosing is very bad, because the router works fare away. The reset switch is bonded, therefore i am shure nobody has reseted it. After the loosing of the settings, the faktory setings are aktiv, after loading of the backup, it works well.
I use the last firmware 1.0.0.72

Any idea what i shall do, is the router defekt?


by a new one ?

[jmizoguchi]

make sure to use UPS backup with it.

any erratic power surge over period time will cause the router to go bad

[hans3]

Originally Posted by jmizoguchi

make sure to use UPS backup with it.

any erratic power surge over period time will cause the router to go bad

I think a little bit oversized UPS Backup? Not usual for such products.

I also use the MBR624GU without problems, but i need the trafic limitation
therefore i use the MBRN3000

Is it possible that the new firmware makes this problems?

has nobody this problem?

[jmizoguchi]

I think a little bit oversized UPS Backup? Not usual for such products.

???

small 350 APC UPS for 40 bucks will save you buck but that is your money so I wouldn't care for it for your investment

I also use the MBR624GU without problems, but i need the trafic limitation
therefore i use the MBRN3000

you will not abel to limits the bandwidth anyway for single user or entire network

Is it possible that the new firmware makes this problems?

I doubt it but you can request to support at my.netgear.com

don't expect to see any changes in firmware by next week

[hans3]

thank you for your information.
I didn't know that so cheap UPS's exit, I will try it

[jmizoguchi]

You should able to find UPS from $40-59
Keep watching some ads..

Good luck