WNR3700L - how to extend GUEST network

[johnasher]

i have a 3700 connected by wire to another switch which is connected to an AP. however when connecting to the AP you can see the whole network.

I want to extend ONLY the GUEST access.

does anyone know how to configure this? Is it possible? Any other solution?

[jmizoguchi]

if you are just are repeating? if so answer is no...

[Ehren8879]

The AP would need to have guest network capabilities to limit its network access.

[jmizoguchi]

3700 has guest network . all depends on setup

[jlewter]

Your AP would need to be w wireless repeater, repeating the Guest WIFI signal. This isnt possible to do through a wired setup unless you were to add additional hardware, or run 3rd party firmware. Even if using 3rd party firmware you may not get iot all to fully function without a lot of effort.

[johnasher]

In the end my solution is less than elegant but it works.
I used a WN2000RPT range extender which I wirelessly connected to the router's guest SSID and connected it with a wire to an old AP that I had.

As I said, not elegant, but it works.